Yaesu Wires-X and FTM-100 DR Setup

This is a quick video to show some of the confusion I had when setting up my Yaesu wires X node to my radio, and how to set it up properly. Hope it helps some of you out there!
Wires node: 21606




5 comments:

  1. thanks for info....after pressing both buttons on power up my 100 displays Yaesu/wires-x, but is stuck there..cannot reset defaults, only key that works now is disp/setup and it powers the unit off? Have you seen this,,,,thanks Bob, K7YRC

    ReplyDelete
  2. thanks for making this video,it help me out especially setting the radio into wires x mode and now its working ,only problem it only works on digital setting ?
    thanks
    vk1mdj

    ReplyDelete
  3. Anonymous10/08/2016

    need help my yaesu ftm-100dr is also stuck in wires-x mode only buttom that works is disp setup . n3jpp john johnn3jpp @comcast.net thank u

    ReplyDelete
  4. I have the same issue with my FTM-100DR? I want to change a frequency and I can't get it out of Wires-X mode. Any solutions to this?

    ReplyDelete
  5. Hello, we have a weird issue here. We use a DR1 repeater with the following set-up: input frequency: 144,600 output frequency: 430,400. When we connect to Wirex-x with a handheld rtx(ft1 or ft2) there is no problem, but when we try to connect a mobile rtx like FTM100 and FTM 400 we cannot connect to wires-x. We can speak, the repeater is ok but the connection is refused. Only with the mobile rtx!!!! We also have tried with several ftm 100/400, allwith the last firmware (the dr1 also). It seems that the only rtx you can use is a handheld rtx with this repeater configuration. Any suggestions? I hope that you can understand my bad english...
    Thank you and 73

    ReplyDelete

Yaesu System Fusion (groups.io) Discussion
https://groups.io/g/YaesuSystemFusion
.

Note: only a member of this blog may post a comment.